Vogue Industrial ABOVE GROUND SWIMMING POOL Specifications download pdf (Page 13)

THRU-THE-WALL SKIMMER

IMPORTANT!! BEFORE CONTINUING WITH THIS STEP

YOU MUST KNOW WHICH TYPE OF THROUGH THE WALL SKIMMER

YOU WILL BE USING WITH YOUR POOL

Your pool wall has cutouts to accomodate both standard size skimmers and deluxe wide mouth

skimmers. If you have a wide mouth skimmer, you will be required to remove the entire cutout as

shown in figure 1. To remove the section, you can use either tin snips or a hammer and knife as

shown in figure 3. If you have a standard size skimmer, only remove the inside section of the cutout,

and place duct tape around the remaining scored sections as shown in figure 2.

LARGE SKIMMER

CUT OUT ENTIRE AREA

On inside of wall, tape over

holes and slots that will not

SMALL SKIMMER

CUT INSIDE

AREA

be used with duct tape or any

other cloth tape.

ONLY

If the through wall filter inlet and outlet holes are to be used, remove metal cutouts by breaking

perforations using a knife and hammer as shown. Refer to skimmer manufacturer's instructions

for remainder of skimmer assembly. Make sure skimmer does not leak as this will corrode the

pool wall and cause a split in the wall that is not covered under the pool warranty.

It is recommended to coat the exposed metal on both sides with a clear lacquer or nail

polish to help resist rust and corrosion.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

No comments

Vogue Industrial ABOVE GROUND SWIMMING POOL Specifications Page 13