Vogue Industrial ABOVE GROUND SWIMMING POOL Specifications download pdf (Page 14)

CAUTION

YOUR POOL IS DESIGNED TO PROVIDE AN AMPLE SAFETY MARGIN

WHEN IT STANDS ON LEVEL GROUND. FOR THIS PURPOSE A SLOPE

IN EXCESS OF 2 INCHES IN ANY DIRECTION WALL TO WALL IS

CONSIDERED OFF LEVEL YOUR POOL WARRANTY ONLY APPLIES TO

POOLS INSTALLED ON LEVEL GROUND AS DEFINED ABOVE.

ONCE YOU HAVE STARTED TO FILL THE POOL, DO NOT TRY TO PULL

THE LINER FORCEFULLY. THE WEIGHT OF EVEN ONE INCH OF WATER

WILL MAKE IT IMPOSSIBLE TO MOVE THE LINER WITHOUT DAMAGING IT.

LINER INSTALLATION

LINER

STANDARD OVERHANG LINER

1. Clear all sticks and sharp objects from an area near the pool, that is

as large as the pool itself. Remove the liner from its carton and unfold

and open the liner. Refold the liner so that it can easily be carried to

the pool and unfold from the outside of the pool. Check the

levelness of the sand in the pool and make sure that no sharp

objects are still in the pool.

2. Place the liner into the pool while holding onto the top of the

wall section of the liner. Overhang the top wall of the liner over

the pool wall approximately 4” and hold it by temporarily placing

the plastic edging over the liner and the wall. Continue in this

manner around the entire pool.

3. Gently pull on the liner and use a soft bristle broom to remove as many

VINYL LINER

TOP RAIL

PLASTIC EDGING

OUTSIDE VIEW

OF POOL WALL

INCORRECT

CORRECT

POOL

LINER

AIR

SPACE

POOL

LINER

POOL

WALL

EARTH

MOUND

wrinkles as possible on the bottom of the pool. Adjust the overhang of the

liner as needed as you go trying to keep it as equal as possible around the pool.

4. Be sure that the seam of the liner where the wall meets the floor of the liner is evenly centered in the pool.

Start filling the pool slowly with water. Continue pulling gently and working the liner with a broom, and

readjusting the overhang as necessary.

5. Some wrinkling of the liner may be evident and in no way affects the structural strength of your pool.

Once the water is filled to a point that the liner is pressed firmly against the wall install the

thru-the-wall skimmer following its instructions. Then you can fill the entire pool as quickly as

desired. The excess liner material overhanging the wall can either be trimmed later when the pool is

filled, or double folded now to the inside of the pool between the liner and the wall. Permanently install

the plastic edging around the entire pool, not leaving any gaps.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Comments to this Manuals

No comments

Vogue Industrial ABOVE GROUND SWIMMING POOL Specifications Page 14

Comments to this Manuals

Related products and manuals for Above ground pools Vogue Industrial ABOVE GROUND SWIMMING POOL